Lorex Technology L19lD1616501 Manual de usuario descargar pdf (Pagina 39)

39

Record Setup

1. OVERWRITE - Sets the Hard Drive to

overwrite older data when full.

• ON: When the hard drive is full, the

system will overwrite the earliest

recorded video. If the DVR has two hard

drives, the overwriting starts from the

Master drive.

• OFF: The system stops recording when

the hard drive is full. If the DVR has two

hard drives, the system stops recording

when the Master and Slave drive both

are full.

2. MULTIPLEX - Set up the multiplex mode

• Duplex: allows the system to record and

use remote connection simultaneously.

The DVR stops recording while the DVR

enters playback either locally or

remotely. During the remote

connection, the DVR keeps recording if

the client stays at the LIVE mode. It

stops recording when the client enters

the playback mode.

• Triplex: record and playback

simultaneously. The DVR keeps

recording while the DVR enters

playback either locally or remotely.

NOTE: The system is set to Triplex by

default. To playback audio on the System,

perform the following steps:

i. Turn the Audio Setting to ON

ii. Set the unit to DUPLEX MODE

iii. Playback the selected video.

3. QUALITY - Set up the recording picture

quality to Normal, High or Best.

4. RESOLUTION - By lowering the

resolution, the DVR gains the recording

speed but the recorded pictures become

smaller.

Changing the RESOLUTION will NOT

change the recording time on DVR. To

change the DVR's recording duration,

please adjust the DVR's recording speed in

the following three settings.

5. RECORD IN ALARM - Set the recording

speed when an alarm is triggered.

6. RECORD IN MOTION - Set the recording

speed when motion is detected.

7. CONTINUOUS RECORD - Set the

recording speed under the continuous

recording mode.

The recording speed is expressed in

fractions. 1/ 1 is to record at the full

recording speed, which you set in

RESOLUTION. 1 / 2 is to record at half of

the recording speed. 1 /3 is to record at one

third of the recording speed. You can set up

the parameter from 1/1, 1/2, 1/3, 1/4,… to 1/

999.

By lowering the recording speed, the DVR

records less frames but gains a longer

recording duration. If you set the DVR's

recording speed at 1/2, the recording

duration will be two times longer. 1/3 will

make the recording duration three times

longer, and so on.

When the RESOLUTION is set to QUAD

Mode, the selection of the recording speed

is limited to 1/1, 1/2, and 1/3.

All active cameras share the recording

speed. To turn off the recording on a specific

channel, please refer to [SYSTEM

MENU]

’[CONFIGURATION] ’[CAMERA

SETUP] “[CAMERA ACTIVE SETUP].

Please note that channels with video loss

are still active and recording. In other words,

those channels are still sharing the

recording speed.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 57 58

Comentarios a estos manuales

Sin comentarios