Lorex Technology L19lD1616501 Manual de usuario descargar pdf (Pagina 49)

Connecting Motion / Alarm Device - Appendix #4

Motion detection and Alarm controls are enabled through the Menu system on the Observation

System. Additional motion sensor devices can be connected to the system (Motion Sensors,

Door/Window Sensors).

A motion detection or sensor unit can be used to send a signal to the Observation System to

begin camera viewing on the matching Video Channel (when enabled in the Menu, see page 39):

• Example: A Window sensor unit has been installed on Alarm Block port #4. When this sensor

is activated, the camera on DIN or BNC VIDEO port #4 will become active (if enabled in the

MENU on the Observation System)

Installing a Sensor

1. Connect the GROUND Cable to the GND port on the Alarm Block on the Observation System.

2. Connect the SIGNAL Cable to a numbered port.

To start ALARM RECORDING on the System, configure the Alarm Settings in the System Menu.

SENSOR

(Not Included)

OBSERVATION SYSTEM

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 57 58

Sin comentarios

Lorex Technology L19lD1616501 Manual de usuario Pagina 49